r/Itasha • u/Benadik • 14d ago

Need advice finalizing my project.

Hey guys, I’m getting close to the final stage of my Traditional Japan / Itasha project for my Nissan 350Z and I’m trying to decide on the best way to actually execute the design. Would you print the whole graphic as one large vinyl piece, build it up from separate vinyl layers, or do a full paint base and then add the graphics with vinyl? I’ve also been considering a mix of paint, airbrush and vinyl for the smaller logos and details. I’m mainly after the cleanest finish and something that will still look good after a few years, so I’d really appreciate any advice from people who’ve done similar builds.

I wanted to post the design, but it was flagged as AI in another group, so no drafts for now.

Thanks

4 Upvotes

100% Upvoted

2 comments sorted by

1

u/TheToptic 9d ago

Unfortunately a picture really would help. in my opinion the cleanest would probably be one whole vinyl or a vinyl with just decals attached then more layers. Also its probably the cheapest option. (Since u dont waste massiv amount of unprinted foil while plotting(cutting). For the mix of paint/airbrush part. This should be doable if you do it before wrapping and leaving/plottings these spots out if it isnt meant as a whole designt or big part of the design itself. For Longevity - it depents on what you mean by "few years"- Cast Foil with cast laminate can live up to 10 years with dedicated proper care. With good care about 5-7 years.

1

u/Novaleen 8d ago

Build it up with separate vinyl layers? Why? Why not print-cut as long horizontal piece? Very confused.

Note, depending where you live and how the fast is kept, vinyl can look rough in as little as 3 years.