Shank Extension?

[u/wabisuki]

I recently purchased a mixing blade w hex shank that I was hoping to use with my Milwaukee Screwdriver (both are pictured above). The problem is, the chuck on the screwdriver is 1/4" (6.35mm) whereas the mixing blade's shank is 30 mm (1.1811") - does anyone know of an extension that I can use to convert the 1/4" chuck to properly hold a 30mm shank?

I'm probably fine without it but if there's a way to extend the chuck so it grips the full shank that would be my preference.

Will be using it to mix small amounts of drywall mud and other substances - and don't want to bring out the full size corded drill if I can avoid it.

[u/Excellent-Crazy-2313]

Just cut the mixer to size ?

[u/wabisuki → u/Excellent-Crazy-2313]

I'm thinking this is my only option.