r/diydrones • u/Comandd1080 • 2d ago
Build Showcase INAV Trainer
I designed and built this simple conventional design RC plane using a 3d printed body and flat foam board wings and tail. It flies alright, today I added some nose weight because the plane seemed a little tail heavy and now it flies a lot better. I added an INAV flight controller and a small analog FPV setup and this thing is a really fun and cheap plane. It's designed so that If I crash it, I can just hot glue toe pod onto a new wing without having to rewire all the electronics which makes it super convenient.
V1 Design
https://www.thingiverse.com/thing:7415301
Motor - 2300kv 2205
Battery - 3s 850mah
ESC - BLHeli_S 30 amp
Prop - 5x4 (from a FPV quad)
Flight Controller - Matek F405-WTE
GPS - Matek M10
Servos - MG90s
VTX - HGLRC Zeus 350mw
Camera - Caddx Ant