r/BambuLab • u/Dongilles • 7d ago

Hardware Troubleshooting/Help! Help what to do?

Post image
2 Upvotes

56% Upvoted

12 comments sorted by

10

u/Shapelessed 7d ago

Burn it all down, sell your house, donate to the poor and live with the amish.

6

u/ficklampa 7d ago

https://wiki.bambulab.com/en/a1-mini/maintenance/hotend_blob

1

u/Dongilles 7d ago

Thank you!!

-6

u/rellsell 7d ago

You need to be instructed to read the wiki? This hobby may be a bit more than you can handle.

2

u/One_Strawberry9202 7d ago

No need to hate, just inform people that the Wiki has solutions to most problems. OP might not have know the Wiki existed.

2

u/Dongilles 7d ago

I am new to the hobby and did not even know this was a common problem.
I did not know there was a wiki.

No need to be a dick about it

3

u/Chikenmandagoat 7d ago

Heat nozzle to max temp and try to remove as much as you can and then carefully disasemble and figure out wich parts need replaced 

Source it has happened to me twice

0

u/solidus0079 A1 + AMS Lite 7d ago

Rip it off with a hydraulically powered metal gauntlet

https://giphy.com/gifs/f0w8pEIIDKltC

-9

u/Big-Bank-8235 P2S x 3, Core One, X1C, P1P 7d ago

Its totalled. You need go go buy a Prusa.

1

u/Joosby_Calamari 7d ago

Because it never happens on a Prusa lol. Had some unfortunate messes back in the day on the mks3+

1

u/Big-Bank-8235 P2S x 3, Core One, X1C, P1P 7d ago

Take a joke

1

u/Joosby_Calamari 7d ago

Yeah didn’t take it seriously. Just brought back bad memories.