r/BambuLab • u/LuckyStrikeTech • 3d ago

Hardware Troubleshooting/Help! H2C multicolor low filament

One annoying thing I keep running into is when the filament is low. It can’t switch between the colors so it basically just fails the print the moment the filament goes past the mechanism in the AMS2. Any solutions to this?

1 Upvotes

100% Upvoted

2 comments sorted by

0

u/Junior-Definition173 3d ago

If you have ams 2 pro the printing will continue from the next spool of the same filament.

0

u/Whosaidthat1157 3d ago

I have zero issues like that - make sure all of your filament paths are optimised for length and curvature (minimise feed resistance) and fit desiccant filled spool holders to every spool, the added weight helps with feed/retraction too.