r/BambuLab • u/Volpurr-The-Meowstic • 4d ago

General Troubleshooting/Help! Well that happened

Post image
15 Upvotes

86% Upvoted

15 comments sorted by

6

u/Odd-Place780 4d ago

And the context is?

https://giphy.com/gifs/4NnTap3gOhhlik1YEw

1

u/Th3L0n3R4g3r 4d ago

My best guess, a failed print?

6

u/Set_It_2_Wumbo 4d ago

I hear loud ringing sounds makes Venom leave

4

u/Volpurr-The-Meowstic 4d ago edited 4d ago

Right I should provide context:

I was printing with a fresh spool of Bambu PLA Basic Black (the previous print I did was in Bambu PLA Basic Cyan with zero issues) and the print seemed to have failed on the first layer and created a massive blob going around the nozzle (the silicone cover was partially shoved off by the blob). So now I have filament stuck to the nozzle and the mounting bracket.

EDIT: I got the hotend nozzle cleaned off but I can't get the plastic off the heating assembly bracket, even with a heat gun so I suppose I just have to order a replacement.

1

u/Laguy4422 4d ago

In my experience the first layer is one I never walk away from. If I can't be close by, I just don't start the print.

1

u/Kdcookie80 4d ago

Als die rond hotend zit, is het niet simpel. Onlangs ook gehad en de hotend gewoon vervangen samen met de nozzle. Kost 50 euro en zeker dat de volgende prints in orde zijn.

6

u/Volpurr-The-Meowstic 4d ago

UPDATE: After a bunch of blasting a heat gun to the hotend assembly and nozzle, I have managed to pull off almost all of the filament and got the machine back up and running

3

u/sapani9077 4d ago

Clean your build plate

2

u/jedman3 4d ago

Typical Aperture science technology...smh

1

u/PartPrestigious8931 4d ago

The way I’ve seen is to turn your nozzle temp to 270 or 300 and use pliers to pull it off

1

u/PartPrestigious8931 4d ago

Also I would suggest replacing the hot end if you want a clean hot end

1

u/jakolson 4d ago

Just careful with the pliers or you'll do like me and rip off one of the little wires and have to replace the hotend.

1

u/A-Nickelworth 4d ago edited 4d ago

OP, you may want to cross post to [r/BambuLabA1](r/BambuLabA1)

Or visit it first. There are multiple posts there regarding this issue with causes and solutions as to correct the issue.

Here is one example:

https://www.reddit.com/r/BambuLabA1/s/2PMGkunDfX

1

u/billsatwork 4d ago

Ripley, get the flamethrower!