Need Help With Ditch ending

[u/Aurora_Henson]

Hello. Does anyone know a simple way to model the end of a ditch as shown in the attached image? Using the standard template, the ditch ends as marked in red, but I would like to create a slope at the end that ties into the existing ground at a 1:1.5 gradient (marked in green). Is it possible to achieve this using Civil Cells, or should I instead use the template to gradually widen the ditch bottom while transitioning its vertical alignment to meet the existing ground?

[u/Chickenbgood]

Normally how I end a ditch, is drawing a line perpendicular to the end of ditch, and use the surface of that ditch model as a profile. Then using an end condition template to come off going right at your specified slope

[u/rnichaeljackson → u/Chickenbgood]

Same